Metabo BZ 9.6 SP Instrucciones De Manejo página 8

ENGLISH
ENG
5.6 Rapid-action keyless chuck
9
GRIP, ZU
Opening
Twist the sleeve (9) towards "AUF, RELEASE".
Clamping bit
Open the rapid-action keyless chuck and insert
the bit fully.
Twist the sleeve (9) towards "GRIP, ZU", until
the bit is clamped tightly in the chuck.
When using soft bit shanks, it may be neces-
sary to retighten the chuck after a short period
of operation.
Removing the chuck
10
11
Open the rapid-action keyless chuck.
a Loosen the screw (10)
(NB: left-hand thread).
b Screw off the chuck (1) using an open
ended spanner (11).
Replace the chuck by reversing the above
procedure.
8
AUF, RELEASE
1
Cleaning
Clean from time to time by holding the tool with
the rapid-action keyless chuck facing vertically
downwards and twist the sleeve as far as it will
go towards "GRIP, ZU", and then turn back
fully in the opposite direction ("AUF,
RELEASE").
The dust which has accumulated will fall out of
the chuck.
6 Hints and Tips
Drilling
Use of 2nd gear is recommended (higher
speed).
Driving screws
Use of 1st gear is recommended (low speed),
and with the torque control feature in opera-
tion.
Tapping threads
Apply a light film of oil to the tap.
Select 1st gear (low speed).
Switch on torque control.
7 Accessories
Use original Metabo accessories only.
To assist in selecting the correct accessories,
make sure that you take a note of the exact
model of your tool for your dealer.
A Charger
B Holster
C Battery packs of varying capacities.
Buy only battery packs of the correct
voltage for your cordless tool.
8 Repairs
Repairs to power tools must be
carried out by a qualified electrician
only.
Any Metabo power tool in need of repair can be
sent to one of the addresses listed in the spare
parts list.
Please attach a description of the fault to the
tool.