Mottura GARDEN 451 Manual De Instrucciones, Uso Y Mantenimiento página 11

Idiomas disponibles

After the limit stops have been set, you can also set up to two intermediate stopping points (see

attachment "M").

1. Run the system until reaching the position for the first intermediate stopping point

2. Press button "1" on the motor control panel for 5 seconds

3. The corresponding LED will flash to indicate that the control has been received

If you want to set a second intermediate stopping point (not mandatory)

4. Activate the system up to the position where you wish to set the second intermediate stopping

point

5. Press button "2" on the motor control panel for 5 seconds

6. The corresponding LED will flash to indicate that the control has been received

If the intermediate stopping points are set, when the system is run it will reach the first stopping point

in sequence. If you want to open or close the curtain completely, the control (whether from the button or from

the radio control) must be held for 4 seconds (the "RESET" Led on the motor control panel goes out for a

fraction of a second to signal that the command has been received).

By following the above-described procedure, you can change the intermediate stopping points at any

time without having to change the limit stops. To eliminate the intermediate stopping points, simultaneously

press buttons "1" and "2" on the motor control panel for 4 seconds (the corresponding LEDs will flash once to

indicate that the intermediate stopping points have been cancelled).

To control the Garden 451 by radio it must be assigned to a remote control. To perform this operation

carry out the following procedure (see attachment "L" fig "3L").

1. Put the transmitter into the association mode.

Consult the technical manual for the transmitter being used.

2. Press the R. F. button on the motor control panel for 5 seconds (one flash of the "R. F." LED on

the motor control panel confirms that the association procedure has been carried out correctly)

Setting intermediate stopping points

Assigning an R. F. radio receiver