Haier HD80-A3939E-S Manual Del Usuario página 64

WARNING
The appliance must not be
supplied through an external
switching device, such as a
timer, or connected to a circuit
that is regularly switched on
and off by a utility.
Do not use adapters, multiple

connectors and/or extensions.
The plug should be accessible

for disconnection
appliance has been installed.
Do not plug the machine in and

switch it on at the mains until
the installation is completed.
If the supply cord is damaged,

it must be replaced by the
manufacturer, its service agent
or similarly qualified persons in
order to avoid a hazard.
Ventilation
Adequate ventilation must be

provided in the room where the
tumble dryer is located to
prevent gases from appliances
burning other fuels, including
open fires, being drawn into
the room during operation of
the tumble dryer.
Install the rear of the appliance

close to a wall or vertical surface.
There should be a gap of at

least 12 mm between the
machine and any obstrubtions.
The inlet and outlet air should
be kept clear of obstruction.
Make sure carpets or rugs do

not obstruct the base or any of
the ventilation openings.
Prevent items from falling or

collecting behind the dryer as
these may obstruct the air inlet
and outlet.
after the
Exhaust

discharged into a flue which is
used for exhausting fumes
from appliances burning gas or
other fuels.
Check regularly that the air

flowing around the dryer is not
restricted, avoiding accumulation
of dust and lint.
Check frequently the fluff filter

after use, and clean, if necessary.
The Laundry
Always refer to the laundry

care labels for directions on
suitability for drying.
Fabric softeners, or similar

products, should be used as
specified by the fabric softener
instructions.
64
air must not be