Publicidad
Idiomas disponibles
Idiomas disponibles
Replacing the LED Lamp
Cooktop Light/Nite Light
Replace with LED lamp. See back cover for ordering
online at GEAppliances.com.
1. To replace the cooktop light/nite light, first disconnect
the power at the main fuse or circuit breaker panel,
or pull the plug.
2. Remove the screw from the side of the light
compartment cover and lower the cover until it stops.
3. Be sure the LED lamp is cool before removing.
Remove a screw and connector from LED lamp.
4. Connect LED lamp and secure using the screw. Raise
the light cover and replace the screw. Connect
electrical power to the oven.
Optional Kits
Available at extra cost from your GE supplier.
Filler Panel Kits
JX36BWW – White
JX36BBB – Black
JX36BES – Slate
JX36BDS – Dark Slate
JX36BSS – Stainless
JX36BTS – Black Stainless
When replacing a 36" range hood, filler panel kits fill in the
installation. Each kit contains two 3" wide filler panels.
49-7000158 Rev. 2
Filter Panel
JX15BUMP - Bump Out Kit
When installing a microwave in a kitchen with 15" deep
the microwave to be installed 3 inches further out which
prevents the cabinets from blocking the ventilation holes
at the top of the microwave grill.
Filter Kits
Filter kits are used when the oven cannot be vented to the
outside.
Available at extra cost from your GE supplier. See the back
cover for ordering by phone or at GEAppliances.com.
Remove screw.
27
Publicidad
