Gaggia Milano RI8437 Manual Del Usuario página 14

English
14
2 If present, remove the pod filter adapter from the filter holder and rinse it thoroughly with hot
water.
3 Rinse the inside and outside of the pressurized filter holder with hot water (Fig. 14).
Caution: Do not clean the pressurized filter holder in the dishwasher. This will damage the
pressurized filter holder.
Descaling
Please use Gaggia descaler only. Under no circumstances should you use a descaler based on sulfuric
acid, hydrochloric acid, sulfamic or acetic acid (vinegar) as this may damage the water circuit in your
machine and not dissolve the limescale properly. Not using the Gaggia descaler will void your
warranty. Failure to descale the appliance will also void your warranty.
Descaling procedure
1 Insert the pressurized filter holder in the brew unit.
2 Remove and empty the water tank.
3 Pour half of the descaling solution into the water tank. Fill the water tank with fresh water up to the
MAX indication. Place the water tank back into the machine.
4 Set the main switch to 'I' to switch on the machine. Turn the selection knob to the standby position.
5 Place a container under the classic milk frother.
6 Wait until the coffee ready light lights up and brew two cups (of approx. 150ml each) of water.
7 Set the main switch to 'O' to switch off the machine.
8 Let the descaling solution work for 15-20 minutes with the machine switched off.
9 Set the main switch to 'I' to switch the machine back on.
10 Fill two cups (of approx. 150ml each) with hot water from the classic milk frother.
11 Set the main switch to 'O' to switch off the machine and wait 3 minutes.
12 Repeat steps 9-11 until the water tank is empty.
13 Rinse the water tank and fill it with fresh water up to the MAX indication.
14 Place a container under the filter holder.
15 Set the main switch to 'I' to switch on the machine and turn the selection knob to the standby
position.
16 Let the machine dispense water until the water tank is empty. Set the selection knob to the
standby position.
17 Fill the water tank with fresh water up to the MAX indication.
18 Place a large container under the classic milk frother. Turn the hot water/steam knob anticlockwise.
19 Turn the selection knob to the coffee position and let the machine dispense water until the water
tank is empty.
20 Turn the selection knob to the standby position.
21 Turn the hot water/steam knob clockwise.
22 Rinse the machine by repeating steps 13-20 one more time.
23 Remove the filter holder from the brew unit by turning it from right to left and rinse it with fresh
water.
24 Fill the water tank with fresh water up to the MAX indication.
The machine is now ready for use.