SOMFY 100 io Manual De Instrucciones página 19

TUBELITE WHITE RECEIVER 100 io - TUBELITE WHITE RECEIVER 200 io
1.2. LIABILITY
Before installing and using the receiver, please read this instructions guide carefully.
It must be installed by a home automation professional, in accordance with Somfy's instructions and the
regulations applicable in the country in which it is commissioned.
Any operation of the receiver outside the field of application described above is prohibited. Such use, and any
failure to comply with the instructions given in this instructions guide, would exempt Somfy of any liability
and invalidate the warranty.
The installer must inform their customers of the operating and maintenance conditions of the receiver,
and must provide them with the operating and maintenance instructions after installing it. Any After-Sales
Service operation on the receiver must be performed by a home automation professional.
Never begin installing without first checking the compatibility of this product with the associated equipment
and accessories.
In case of any doubt when installing the receiver or for additional information, consult a Somfy contact or
visit www.somfy.com.
2. INSTALLATION
2.1. ASSEMBLY
Warning
• These instructions are mandatory for the home automation professional installing this product.
• Comply with current standards and legislation in the country of installation.
Caution
• Comply with standard NF C 15-100 relating to electrical installations.
• Make sure that the power of the LED lights connected to the receiver does not exceed 4.2 A per output.
Attention
• Cables passing through a metal wall must be protected and insulated using a sheath or sleeve.
• Secure the cables to prevent any contact with moving parts.
• The receiver cable cannot be removed. If it is damaged, return the receiver to the After-Sales service.
• To ensure good radio reception, ensure that the outside antenna is not in contact with any metal item.
• Do not trim the antenna wire.
• Never drop, knock, drill or submerge the product.
2.1.1. Tubelite preparation
1) Fit the accessories required for incorporating the Tubelite into the
roller tube on the other end from the drive using the crown
the drive wheel
2) Measure the length (L) between the inner edge of the Tubelite head
and the rim of the drive wheel.
2.1.2. Tube preparation
On the other end from the drive, deburr the roller tube and remove the
swarf.
Copyright 2023 SOMFY ACTIVITES SA, Société Anonyme. All rights reserved.
©
5175297A000_LEAF.TUBE WHITE REC 100200 io.indb 19 5175297A000_LEAF.TUBE WHITE REC 100200 io.indb 19
on the Tubelite.
b
1) 1)
Ø > 47 mm Ø > 47 mm
and
a
2) 2)
L = ... L = ...
L L
EN
b
a
19
27/10/2023 10:00:36 27/10/2023 10:00:36