Panasonic EY75A8 Manual De Instrucciones página 14

[EY75A8]
EN
• Selecting the impact power among 3
modes (Hard, Soft, Medium).
Press the impact power mode button to
set it. The mode changes to Hard, Soft or
Medium each time the button is pressed.
Hard
EY75A7:
0 – 2500 rpm
and
0 – 3100 i.p.m.
EY75A8:
0 – 2500 rpm
and
0 – 3600 i.p.m.
Medium
EY75A7:
0 – 1450 rpm
and
0 – 2900 i.p.m.
EY75A8:
0 – 1500 rpm
and
0 – 2900 i.p.m.
Soft
EY75A7:
0 – 950 rpm
and
0 – 1900 i.p.m.
EY75A8:
0 – 1000 rpm
and
0 – 1900 i.p.m.
* i.p.m. = Impact per minute.
• Jobs requiring high
torque where there is
no possibility of break-
ing screw or chipping
screw head.
* Fastening larger
size bolt (M8 or
larger)
* Fastening long
wood screw
• Jobs requiring decent
torque with minimizing
the possibility of break-
ing screw, chipping
screw head, or break-
ing bit.
* Fastening smaller
diameter bolt (such
as M6)
• Jobs requiring limited
torque with eliminating
the possibility of break-
ing screw, chipping
screw head, or break-
ing bit.
• Jobs requiring minimal
damage of finished
exterior surface.
* Fastening smaller
diameter bolt (M6 or
smaller)
* Fastening into
plastic
* Installing drywall
Only for EY75A7
Self-drilling screw
0 – 2500 rpm
and
0 – 1200 i.p.m.
* i.p.m. = Impact per minute.
Avoid repeatedly depressing the switch
when the bolts and screws are securely
fastened.
Not doing so may cause a delay in rotation
starting, or the Impact Power mode
display to flash and prevent rotation from
starting for circuit protection.
LED Light
Press the light button and set illumination
condition.
Illuminated
Illuminates by pressing button.
The light turns off when the tool
has not been used for more
than 5 minutes or just after
attaching the battery pack.
Depress the trigger switch and
operate the tool once.
Interlocking trigger
Illuminates while depressing the
trigger switch.
Turns off when the trigger is
released.
Off
The light illuminates with very low current,
and it does not adversely affect the perfor-
mance or its battery capacity.
CAUTION:
• The built-in LED light is designed to
illuminate the small work area tempo-
rarily.
- 14 -
• Jobs requiring flush
finish of self-drilling
screw.
(dia. 4 mm × 15 mm or
smaller)
(Automatic mode
change starting from
Hard mode to slower
rpm before flush finish)