Publicidad
Idiomas disponibles
Idiomas disponibles
DRILLING IN WOOD
Start drilling with slow speed and increase to full power while applying
firm pressure on the tool. Holes in wood can be made with the same
twist drills used for metal. These bits may overheat unless pulled out
frequently to clear chips from the flutes. Work that is apt to splinter
should be backed up with a block of wood.
DRILLING IN MASONRY
When drilling in masonry, use carbide-tipped bits rated for percussion
drilling and be certain that the bits are sharp. Use a constant and firm
force on the tool to drill most effectively. A smooth, even flow of dust
indicates the proper drilling rate.
MAINTENANCE
Your D
WALT power tool has been designed to operate over a
E
long period of time with a minimum of maintenance. Continuous
satisfactory operation depends upon proper tool care and regular
cleaning.
WARNING: To reduce the risk of injury, turn unit off and
disconnect tool from power source before installing and removing
accessories, before making any adjustments or removing/installing
attachments or accessories.
Motor Brushes
D
WALT uses an advanced brush system which automatically stops
E
the drill when the brushes wear out. This prevents serious damage
to the motor. New brush assemblies are available at authorized
D
WALT service centers. Always use identical replacement parts.
E
Lubrication
Self-lubricating bearings are used in the tool and periodic relubrication
is not required. In the unlikely event that service is ever needed, take
your tool to an authorized service location.
Cleaning
WARNING: Blow dirt and dust out of the main housing with dry air
as often as dirt is seen collecting in and around the air vents. Wear
approved eye protection and approved dust mask when performing
this procedure.
WARNING: Never use solvents or other harsh chemicals for
cleaning the non-metallic parts of the tool. These chemicals may
weaken the materials used in these parts. Use a cloth dampened only
with water and mild soap. Never let any liquid get inside the tool;
never immerse any part of the tool into a liquid.
Accessories
WARNING: Since accessories, other than those offered by
D
WALT, have not been tested with this product, use of such
E
accessories with this tool could be hazardous. To reduce the risk of
injury, only D
WALT, recommended accessories should be used with
E
this product.
Recommended accessories for use with your tool are available at
extra cost from your local dealer or authorized service center.
CAUTION: To reduce the risk of injury, the following accessories
should be used only in sizes up to the maximums shown in the table
below.
MAXIMUM RECOMMENDED CAPACITIES
Chuck capacity
Bits, metal drilling
Wood, flat boring
Masonry
28
DWD024
13 mm
13 mm
25 mm
16 mm
Publicidad
