Publicidad
Idiomas disponibles
Idiomas disponibles
STEP 6
PREPARING THE DISHWASHER
1.
2.
Use the provided nut connector to connect the water hose to the dishwasher.
Follow these steps:
1
A
B
1)
Disconnect the 90° fi tting (A) from the hose (B).
2)
Remove the seal (C) and the nut (D) from the 90° fi tting.
3)
From the provided nut connector, separate the seal (E) and the nut (F), and then
assemble them to the 90° fi tting as shown in the fi gure. You must insert the smaller side
of the seal.
3.
Then, insert the ¾" 90 degree fi tting into the inlet valve (see Figure 4-B). Tighten until the ¾"
fi tting is tight. Do not over tighten.
rear
2
3
E
C
D
F
Publicidad
