Publicidad
Idiomas disponibles
Idiomas disponibles
How to Assemble Your Ceiling Fan
1.
Remove the hanger ball portion from the downrod/
hanger ball assembly by loosening the set screw in
the hanger ball until the ball falls freely down the
downrod. Remove the pin from the downrod, then
remove the hanger ball. Retain the pin and hanger
ball for reinstallation in Step 7. (Figure 1)
2.
Remove the hairpin clip and clevis pin from the
bottom of the downrod. Retain the pin and clip for
reinstallation in Step 4. (Figure 2)
3.
Loosen the two set screws and locking nuts in the
downrod support of the motor housing assembly.
Route the black, white and blue wires through the
downrod. (Figure 3)
4.
Slide downrod into the downrod support on top of
the motor housing assembly. Install the clevis pin by
aligning the holes in the downrod support with holes
in the downrod. Secure clevis pin with hairpin clip.
Tighten the two set screws with nuts in the downrod
support. Securely tighten the set screws with
screwdriver then fully tighten the nuts by hex wrench.
(Figure 4)
WARNING
It is critical that the clevis pin in the downrod support
is properly installed and the set screws and nuts are
securely tightened. Failure to do so could result in
the fan falling.
Downrod
Hanger Ball
Hairpin Clip
Set Screws and
Locking Nuts (2)
Downrod
Hairpin Clip
Clevis Pin
7
Pin
Set Screw
Figure 1
Clevis Pin
Figure 2
Black, White and
Blue wires
Figure 3
Set Screws and
Locking Nuts (2)
Figure 4
Publicidad
