Descargar Imprimir esta página

Sony Trinitron CPD-G420S Manual De Instrucciones página 16

Publicidad

Idiomas disponibles

Idiomas disponibles

Restoring the color from the EASY, PRESET, or
sRGB modes (IMAGE RESTORATION)
The colors of most display monitors tend to gradually change
brilliance over several years of service. The IMAGE
RESTORATION feature found in the EASY, PRESET, and
sRGB menus allows you to restore the color to the original factory
quality levels. The explanation below explains how to restore the
monitor's color from the EASY mode for example.
First, select the EASY, PRESET, or sRGB mode in the OPTION
menu (page 14).
1
Press the MENU button.
The menu appears on the screen.
2
Move the control button up or down to highlight
COLOR and press the control button.
The COLOR menu appears on the screen.
3
Move the control button up or down to highlight
IMAGE RESTORATION. Then press the control
button.
4
Move the control button up or down to select OK.
Then press the control button.
The picture disappears while the color is being restored (about
2 seconds). After the color is restored, the picture reappears
on the screen again.
Notes
• Before using this feature, the monitor must be in normal operation
mode (green power indicator on) for at least 30 minutes. If the monitor
goes into power saving mode, you must return the monitor to normal
operation mode and wait for 30 minutes for the monitor to be ready.
You may need to adjust your computer's power saving settings to keep
the monitor in normal operation mode for the full 30 minutes. If the
monitor is not ready, the following message will appear.
• The monitor may gradually lose its ability to perform this function due
to the natural aging of the picture tube.
16
Downloaded from:
https://www.usersmanualguide.com/
COLOR
I MAGE
RESTORAT I ON
OK
CANCEL
X I T :
E
MENU
COLOR
I MAGE
RESTORAT I ON
AVA
I
LABLE
AFTER
WARM UP
X I T :
E
MENU
Additional settings (OPTION)
You can lock the controls, change the on-screen language, change
the menu position, and set the COLOR mode.
1
Press the MENU button.
The menu appears on the screen.
2
Move the control button up or down to highlight
OPTION and press the control button.
The OPTION menu appears on the screen.
3
Move the control button up or down to select the
desired adjustment item.
Adjust the selected item according to the following
instructions.
x Locking the controls (CONTROL LOCK)
You can protect the adjustment data by locking the
controls. Move the control button up or down to
highlight
(CONTROL LOCK) and press the control
button. Then move the control button up or down to
select ON and press the control button.
Only the ! (power) switch, MENU button, INPUT switch, and
(CONTROL LOCK) of the
If any other items are selected, the
screen.
To cancel the control lock
Repeat the procedure above and set
x Changing the on-screen language
(LANGUAGE)
See page 8.
x Changing the menu's position
(OSD POSITION)
Change the menu's position if it is blocking an image on the
screen.
Move the control button up or down to select
POSITION) for horizontal adjustment, or
POSITION) for vertical adjustment and press the
control button. Then move the control button up or
down to shift the on-screen menu.
x Setting the COLOR mode
See page 14.
OPTION menu will operate.
mark appears on the
(CONTROL LOCK) to OFF.
(OSD
(OSD

Publicidad

loading