Closing The Door; Installation; Ventilation Requirements; Noises - AEG SCZ81800C0 Manual De Instrucciones

18 www.aeg.com

8.3 Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to

"Installation".

9. INSTALLATION
9.1 Positioning
Install the appliance in a dry, well
ventilated indoors where the ambient
temperature corresponds to the climate
class indicated on the rating plate of the
appliance.
Climate
class
SN
N
ST
T
Some functional problems
might occur for some types
of models when operating
outside of that range. The
correct operation can only
be guaranteed within the
specified temperature
range. If you have any
doubts regarding where to
install the appliance, please
turn to the vendor, to our
customer service or to the
nearest Authorised Service
Centre.
9.2 Electrical connection
• Before plugging in, ensure that the
voltage and frequency shown on the
rating plate correspond to your
domestic power supply.

10. NOISES

There are some sounds during normal running (compressor, refrigerant circulation).
Ambient temperature
+10°C to + 32°C
+16°C to + 32°C
+16°C to + 38°C
+16°C to + 43°C
3. If necessary, replace the defective
door gaskets. Contact the Authorised
Service Centre.
• The appliance must be earthed. The
power supply cable plug is provided
with a contact for this purpose. If the
domestic power supply socket is not
earthed, connect the appliance to a
separate earth in compliance with
current regulations, consulting a
qualified electrician.
• The manufacturer declines all
responsibility if the above safety
precautions are not observed.
• This appliance complies with the
E.E.C. Directives.

9.3 Ventilation requirements

The airflow behind the appliance must
be sufficient.
min.
5 cm
200 cm
CAUTION!
Refer to the assembly
instructions for the
installation.
2
min.
2
200 cm