Numeric Buttons - Lenco KCR-11 Manual De Usuario

FRONT PANEL
1. STANDBY
Press to turn on the unit. Press again to turn off and go to Standby mode
2. LIGHT ON/OFF
Slide to turn on or turn off the downward lighting

3. NUMERIC BUTTONS

Press to direct tune to the stored preset FM channel
4. DISPLAY
5. SCAN/ST-MONO
Press to toggle between FM Stereo and Force Mono reception
Press and hold to start the full auto-scanning and store the available FM channel
6. /MIN.
FM: Press to tune to different frequency. Press and hold to auto-scan the next available channel
Timer Setup: Press to setup the minute setting
7. /SEC.
FM: Press to tune to different frequency. Press and hold to auto-scan the next available channel
Timer Setup: Press to setup the second setting
8. MEM./CLOCK SET
FM: Press to tune to different stored preset FM channel. Press and hold to store the preset FM channel as desired.
In Standby: Press and hold to enter the clock setup operation
9. TIMER
Press to enter the Timer Setup
10. – VOLUME +
Adjust the volume control
11. FM Freqency 0.05MHz LED
When the FM frequency of 0.05MHz is received, this LED will turn on. For example when 88.15MHz is received, the display will
show "88.1" and this LED will turn on
12. FM LED
It is an indicator and turn on when it is in FM mode
13. FM-ST LED
It is an indicator and turn on when it is in FM Stereo mode
14. PM LED
It is an indicator and turn on when it is in 12 hours display format at afternoon time
15. TIMER LED
It is an indicator and turn on when the timer is set
6