Descargar Imprimir esta página

cecotec BOLERO FLUX TM 603500 INOX A Manual De Instrucciones página 48

Campana extractora t

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 38
ENGLISH
1.
To prevent the outer surface of the kitchen hood from deteriorating over time, it is
recommended that it be cleaned with hot water and a non-corrosive detergent every
two months.
2.
Do not use abrasive detergents. Otherwise, the surface of the kitchen hood may be
damaged.
3.
Keep the motor and other parts away from water, as water may damage the appliance.
4.
The carbon filter must not be exposed to heat.
Cleaning aluminium filters
Fig. 9
Do not use corrosive detergents to clean grease from the aluminium filters. Regular cleaning
of the aluminium filters will prolong the life of the appliance and keep it in good working order.
Follow the instructions below:
Cleaning method 1:
Immerse the aluminium filters in hot water (40-50 °C), add neutral detergent and let them
soak for 2 to 3 minutes. Protect yourself with gloves and clean the filters with a soft brush
or scouring pad. Do not apply too much force, as filters are very delicate and can be easily
damaged.
Cleaning method 2:
If you wish, you can also wash the filters in the dishwasher at a temperature of approx. 60 °C.
Carbon filter. Fig. 10
This type of filter has activated carbon and purifies air and absorbs cooking odours. The
activated carbon becomes saturated after a period of time, which will reduce the adsorption
capacity of the filter. The carbon filter cannot be washed nor cleaned in any way. When its
service life comes to an end you must replace it with a new one.
1.
Remove the aluminium filters.
2. The carbon filters are located on both sides of the motor. Turn them until they are firmly
fixed.
3. To replace the carbon filter, proceed in reverse order.
Carbon filter dimensions: Φ132*18.5 mm
Replacing the light bulb/lamp
Please note:
-
The light bulb must be replaced by the official Cecotec Technical Support Service or
similarly qualified technicians.
-
Always disconnect the power supply before performing any operation on the appliance.
When handling the bulb, make sure that it has cooled down completely before any direct
contact with your hands.
48
BOLERO FLUX TM 603500 INOX A
BOLERO FLUX TM 703500 INOX A

Publicidad

loading

Este manual también es adecuado para:

Bolero flux tm 703500 inox a0287602877