cecotec CONGA PERFECT&CLEAN CONNECTED VITAL Manual De Instrucciones página 46

ENGLISH
Recommendation
It is recommended to clean the side brushes once a week with the help of the autoclean brush.
Sensors
- Your robot vacuum cleaner has different types of sensors, for example, proximity sensors
that allow the robot to move around while detecting obstacles, or free-fall sensors that
help the robot detect slopes or possible gaps/unevenness such as staircases. These
sensors are always in contact with dust particles, and therefore can deteriorate over time,
causing possible navigation errors.
- It is suggested to clean all the robot sensors with a dry and soft cloth after a maximum of
35 hours of operation or less.
Battery charge and replacement
- To lengthen the battery shelf life, keep the robot charging on the charging base when not
in use.
- Remove the battery and store it in a safe, dry place if the device will not be used for a long
period of time.
To replace the battery, follow the instructions below:
1. Unscrew the 2 screws on the battery slot, remove the battery cover and the battery. Fig.
29
2. Insert the new battery with the battery label facing up. Fig. 30
3. Place the battery and the battery cover in its place and fix properly the screws back again.
6. TROUBLESHOOTING
Beeps while the oscillating red light is on:
Beeps Error
01 1 Gyroscope error
02 2 Bumper error
03 3 Free-fall sensor
error
46
Solution
Place the robot vacuum cleaner on a stable surface and
restart it by turning it off and on with the power switch. Do
not move it.
Check the bumper and remove any object that may be
blocking it.
Check if the bumper is dirty and clean the sensor.