Publicidad
Idiomas disponibles
Idiomas disponibles
Your Group 1-2-3 booster seat
(2)
1. Adjustable headrest
2. Harness straps (x2)
3. Folding armrest (x2)
4. Shell
5. Adjustment strap (x2)
6. Crotch strap
7. Harness buckle
8. Adjuster (x2)
9. Reducer cushion (depending on the model)
10. Safety cover (x2)
11. Diagonal belt guide (x2 - used without the harness)
Your Group 2-3 booster seat
(2)
1. Height adjustable head support
2. Diagonal belt guide (x2)
3. Back
4. Seat
5. Instruction manual pouch (depending on the model)
Group 1, from 9 to 18 kg
(from approximately 9 months to 4 years)
Make sure that the harness of your car seat is adapted to the height of your child before
starting to install the seat in your car.
The harness can be adjusted to three different heights. The straps must pass through
the holes that are closest to your child's shoulders. If your child's shoulders are between
two levels, always use the higher of the two. To adjust the height of the harness, remove
the upper section of one of the harness straps by twisting the metal keeper located be-
hind the backrest
(3)
and then pulling the end of the harness strap through the slots of
the shell and the cover (4). Feed the end of the harness strap through the same slots at
the desired height, both in the cover and the shell
(5)
and reattach it behind the back-
rest (6). Make sure that the metal anchor is correctly positioned and that the end of the
harness strap is not twisted. Repeat the operation on the second strap.
•
To tighten the harness: Pull on the adjusting straps positioned on the harness. You do
not need to press on the adjuster buttons (7).
•
To loosen the harness: Press on the adjuster buttons positioned on the upper section
of the harness, grasp the lower section and pull simultaneously (8). Press on the red
harness button on the buckle to free your child completely.
Place the car seat against the back seat of the vehicle (9). Lower the headrest as far
as possible. Pull on the vehicle seat belt until it is completely loose. Feed both straps
of the belt through the openings in the cover and the backrest shell
(10)
making sure
the waist strap passes under the arm rest of the car seat and that the diagonal strap
rises vertically between the backrest and the head support without passing through the
belt guide. Bring the vehicle belt out through the opposite openings (11). Make sure
20
GB - User guide
Publicidad
