Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
1. Use plugs and screws to install the appliance.
2. Drill two holes in the wall 2 meters above the floor.
3. Make sure the distance between the holes is 315 mm.
Note: maximum weight is 4.1kg, the wall should be able to carry this weight.
Present time setting:
At the first time the heater will start up or after the power has been cut off the present
time has to be set.
•
Set day of the week, led display 01 is Monday, 02 is Tuesday .. 07 is Sunday. Press +
or – button to select the present day and confirm by pushing the OK button.
•
Set hours, led display 0H, press + or – to adjust the hour from 0H to 23H, press OK
button to confirm.
•
Set minutes, led display 00, press + or – to adjust the minutes from 0min to 59min,
press OK button to confirm.
•
If OK button is not pressed within 10 seconds after the adjustment, the setting will
be cancelled.
1. The distance between the product and
the ceiling (and the side) should be
≥30cm.
2. Keep the tips of the screws out of the
wall for 10 mm.
3. Fix the appliance to the wall by using
the screws.
4. When the product is installed, the hook
(screw) is aligned with the hole "A" on
the product. After hanging, the product
must be moved to the "B", in order to
firmly fix. To remove the product, move
it from "B" to "A" then take out.
English - 5
Publicidad
