EINHELL PICOBELLA 18/90 Manual De Instrucciones Original página 21

6.1 On/Off switch (Fig. 14 / Item 2)
a) Switching on
Press the On/Off switch (Fig. 14 / Item 2).
b) Switching off
Press the On/Off switch again (Fig. 14 / Item 2).
6.2 Speed switch (Fig. 14 / Item 3)
"I" => Low speed, longer battery running time.
"II" => High speed, shorter battery running time.
Pressing several times will change the speed (I/II).
6.3 Practical tips
Important! Use only original accessories.
•
For optimum cleaning results always select
the correct accessories for the job in hand.
See section 5.1 for guidance. Before you use
an accessory, test its suitability on an incons-
picuous area.
•
Do not use any worn accessories.
•
Take care to apply uniform contact pressure.
•
Excessive contact pressure will not result in
better cleaning results. The machine and the
accessories will suffer greater wear.
Cleaning
•
The surroundings of the area you want to
clean can be protected from splashing by me-
ans of suitable coverings.
•
Use a suitable cleaning agent to dampen your
choice of accessories or spray the agent on
the surface you want to clean.
•
To prevent splashing, do not switch on the
machine until you have placed the accesso-
ries evenly on the surface to be cleaned.
•
Guide the MEDIUM 90/20 roller-shaped
brush slowly and in lines (similar to a broom)
over the surface to be cleaned.
•
Round accessories must be guided slowly
and in circles over the surface to be cleaned.
7. Cleaning, maintenance and
ordering spare parts
Before putting away or cleaning the equipment,
switch off and remove the battery pack.
Anl_Picobella_18_90_SPK13.indb 21 Anl_Picobella_18_90_SPK13.indb 21
GB
7.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it down with compressed air at
low pressure.
•
We recommend cleaning the equipment im-
mediately each time after use.
•
Clean the equipment regularly with a damp
cloth. Do not use cleaning agents or solvents;
these may be aggressive to the plastic parts
in the equipment. Ensure that no water can
get into the interior of the equipment. The
ingress of water into an electric power tool
increases the risk of an electric shock.
7.2 Maintenance
There are no other parts inside the equipment
which require maintenance.
7.3 Ordering spare parts
Please provide the following information when
ordering spare parts:
•
Type of unit
•
Article number of the unit
•
ID number of the unit
•
Spare part number of the required spare part
For our latest prices and information please go to
www.Einhell-Service.com
8. Storage
Store the equipment and its accessories in a dark
and dry place at above freezing temperature.
The ideal storage temperature is between 5 and
30 °C. Store the electric equipment in its original
packaging.
Do not bend the rubber lips of the splash guard
(Fig. 1/Item 7) outwards. Store the equipment in
such a way that the rubber lips are not in contact
with the fl oor/ground as far as possible.
8.1 Wall bracket (Fig. 15)
You can use the wall bracket (Fig. 2 / Item 15) for
storage purposes.
Caution! Check that there are no electric cables
or other installations (such as water pipes) near
the drill holes. Make sure that the wall bracket is
fi tted securely and horizontally. Use only suitable
fasteners on a wall capable of bearing the load.
- 21 -
19.09.2023 15:38:47 19.09.2023 15:38:47