Permobil ROHO AGILITY Manual De Instrucciones página 12

Seat Depth and Angle Adjustment, continued
To Adjust the Angle
1. Make sure the width/height adjustment nuts are completely tightened. See "AGILITY Installation".
2. If not yet loosened, use the Allen wrench to loosen the depth/angle adjustment bolts, approximately two
(2) full rotations.
3. Pivot the back shell.
IMPORTANT! To make sure both sides are rotated to the same angle, compare the markers on the
front of both double hooks.
Note: 5 degree increments per mark (15 degrees of anterior and posterior tilt).
2x
IMPORTANT! After installation and adjustment is complete, tighten hardware securely before transferring into the wheelchair. Refer to the appropriate
sections in this manual for recommended torque specifications. If the individual is seated in the wheelchair, and depth and angle re-adjustments are needed,
review "Warnings" at the beginning of this section and re-adjust as necessary. Retighten all hardware securely.
Flip the Back Shell
1. Remove the AGILITY from the wheelchair. See "AGILITY Removal".
2. Remove the back shell hardware on both sides:
- Use the box end wrench to remove the width/height adjustment nuts.
- Remove the triangle brackets from the back shell.
ROHO AGILITY Quick Release Hardware Operation Manual
markers on double
hooks
Triangle Bracket
4. While you hold the back shell in position, use the
Allen wrench to tighten the right and left depth/
angle adjustment bolts, turning until snug + one-
quarter turn.
Note: If a torque wrench is available, tighten the
bolts to 60 ± 4 inch-pounds (7 ± 0.5 Newton
meters).
3. Rotate the back shell.
4. Install and adjust the AGILITY. See all adjustment and installation instructions
provided with the product.
Note: When installing the flipped back shell, make sure the AGILITY Cover is
also in the flipped position.
10