Permobil ROHO AGILITY Manual De Instrucciones página 8

Cane Hardware Installation, continued
6. Tighten the bolts with the Allen wrench until snug + one- quarter turn.
Note: If a torque wrench is available, tighten the bolts to no more than 40
inch-pounds (4.5 Newton-meters).
IMPORTANT!
» Compare the cane brackets to make sure the upper pins are aligned and
the lower pins are aligned.
» Make sure each cane bracket is installed on the correct side.
» Use a tape measure to make sure the cane brackets are at the same
height.
AGILITY Installation
STOP: If the back shell hardware is not yet installed on the AGILITY back shell, see "Back Shell Hardware Installation".
Warnings:
- DO NOT install an AGILITY while the individual is seated in the wheelchair.
- After you install or adjust an AGILITY, and before the individual transfers into the wheelchair, take the following safety precautions:
» Make sure that both safety locks are in the LOCKED ( ) position. To test the locks, use the handle to pull up on the AGILITY.
IMPORTANT! DO NOT use the handle to pull the wheelchair while the individual is seated in the wheelchair. The handle is intended only to assist with
installing and removing the AGILITY.
» Make sure both latches are fully closed. If the latches will not close, or if the hooks will not rest completely on the pins, see "Troubleshooting".
» Make sure that all hardware is securely tightened. Refer to the recommended torque specifications.
- While the individual is seated in the wheelchair, make sure that both of the safety locks remain in the LOCKED ( ) position.
Notes:
- The safety locks must be in the UNLOCKED (
- The cover should be installed on the back shell before installing an AGILITY. Refer to the instructions provided with the ROHO AGILITY Back Support.
Adjust the Width:
1. Caution: Loosen, but DO NOT remove, the width/height adjustment
nuts:
The width/height adjustment nuts should be just loose enough for the
triangle brackets to slide backward and forward.
ROHO AGILITY Quick Release Hardware Operation Manual
) position to install an AGILITY.
2. Tilt the top of the back shell toward the front of the wheelchair and place
6
the lower hooks onto the lower pins.