Permobil ROHO AGILITY Manual De Instrucciones página 14

Troubleshooting
For additional assistance, contact the equipment provider, distributor, or Customer Support.
Not able to correctly attach » Make sure that both the left (L) and right (R) cane brackets are in line with the frame of the wheelchair and are not twisted.
components during cane
» Make sure that the cane brackets are the same height on both sides. Use a tape measure or ruler, if necessary.
hardware installation.
» The normal installation location of the cane brackets is on the back side of the canes. If a rigidizer bar interferes with the cane
Not able to correctly attach » Make sure that both the left (L) and right (R) cane brackets are in line with the frame of wheelchair and are not twisted.
or secure components during
» Make sure that the width is set appropriately for the wheelchair. The distance between wheelchair canes may vary. If the back
AGILITY installation.
» If latches will not close, check to see if safety locks are in the LOCKED ( ) position. Safety locks should be in the
» Inspect components for damage and replace if necessary. Contact Customer Support.
Not able to correctly attach » Make sure the back shell hardware -- left (L) and right (R) -- are on the correct sides.
components during AGILITY
» Make sure the width/height adjustment nuts are in the same position in the triangle brackets. Use the reference grooves as
installation and height
adjustment.
» Make sure that the back shell hardware is the same height on both sides. For each side, count the number of square openings
Not able to correctly attach » Make sure that the left (L) and right (R) depths are equal. Compare the markers on the top of the triangle brackets.
components during seat depth
» Make sure that the left (L) and right (R) double hooks are rotated to the same angle. Compare the markers on the front of both
and angle adjustment.
A component is damaged. Contact Customer Support for a replacement.
Cleaning and Disinfecting
Warnings:
- Cleaning and disinfecting are separate processes. Cleaning must precede
disinfection. Before use by a different individual: clean, disinfect, and check
product for proper functioning.
- Clean the product regularly and when it becomes soiled.
To Clean Hardware: Hand wash with a sponge, using soap and water. Rinse with clean water. Wipe dry with a clean cloth and then allow to
air dry completely.
Recommendation: When washing by hand, use room-temperature water.
To Disinfect Hardware: Wipe gently with a cloth dampened with a household disinfectant. Rinse with clean water. Wipe dry with a clean cloth
and then allow to air dry completely.
Care Symbols
Hand wash.
ROHO AGILITY Quick Release Hardware Operation Manual
brackets when they are installed in the normal location, the cane brackets may be installed on the front side of the canes.
In either orientation, the left (L) and right (R) directional markers on the cane brackets should be correctly located from the
viewpoint of the installer.
shell hardware will not hook to the upper and lower pins of the cane brackets, or if latches will not close, a width adjustment
may be needed. Adjust the width as described in "AGILITY Installation". It may take a few attempts to find the ideal width
position for the wheelchair.
UNLOCKED ( ) position to install the AGILITY, and then LOCKED ( ) before the individual is seated in the wheelchair.
guides. See "AGILITY Installation".
that are visible in the sliding height adjustment bar (See "Height Adjustment" and "Parts Detail".)
double hooks.
Dry flat.
Cautions:
- DO NOT use abrasives such as steel wool or scouring pads on components
of an AGILITY.
- DO NOT use cleaning products containing petroleum or organic solvents [i.e.
acetone, toluene, Methyl Ethyl Ketone (MEK), naphtha, dry cleaning fluids,
adhesive removers] on components of an AGILITY.
12
Wipe with a damp cloth.