Candy CI642CTT Manual De Instrucciones página 13

Using your Induction Hob
To start cooking
1. Touch the ON/OFF control.
After power on, the buzzer beeps once, all displays show
" – " or " – – ", indicating that the induction hob has entered the
state of standby mode.
2. Place a suitable pan on the cooking zone that
you wish to use.
• Make sure the bottom of the pan and the surface
of the cooking zone are clean and dry.
3. Touching the heating zone selection control, and
a indicator next to the key will flash.
4. Set a power level by touching the "-" or "+" control.
a. If you don't select a heat zone within 1 minute, the
induction hob will automatically switch off. You will need to
start again at step 1.
b. You can modify the heat setting at any time during cooking.
If the display flashes
setting
This means that:
• you have not placed a pan on the correct cooking zone or,
• the pan you're using is not suitable for induction cooking or,
• the pan is too small or not properly centred on the cooking zone.
No heating takes place unless there is a suitable pan on the cooking zone.
The display will automatically turn off after 1 minutes if no suitable pan is placed
on it.
alternately with the heat
EN-12