Publicidad
Idiomas disponibles
Idiomas disponibles
IV. Electric Diagram
Installation Instructions
V.
Before using your thermoelectric cooler
Remove the exterior and interior packing
Check to be sure the following parts are included:
For WCL-6T, 2 wooden shelves;
For WCL-12W, 5 wooden shelves;
1 Instruction manual.
Before connecting the appliance to the power source, let it stand upright for approximately 2 hours.
This will reduce the possibility of a malfunction in the cooling system from handling during
transportation.
Put on the space holder inside the manual bag, it helps to keep space between machine and the
wall to make it proper air ventilation
Clean the interior surface with lukewarm water using a soft cloth.
Place your appliance on a floor that is strong enough to support the appliance when it is fully
loaded. To level your appliance, adjust the front legs at the bottom of the appliance.
For recedes installation away from direct sunlight and sources of heat (stove, heater, radiator,
etc.).Direct sunlight may affect the acrylic coating and heat sources may increase electrical
consumption. Extreme cold or hot ambient temperatures may also cause the appliances not to
perform properly.
Not designed for placement in adage or basement.
6
Publicidad
