Teka HLB P Serie Guia Del Usuario página 29

IMpoRTaNT
This function can only be selected when the
oven command functions are set to the rest
position .
Once the door has been locked, you can
start cooking normally.
To activate/deactivate the door lock, follow
these steps:
1. Touch or until the
display starts flashing.
The current door lock status will be dis-
played: "On" if it is active and "Off" if deac-
tivated.
2. Press . You will then hear a beep and the
block will start to activate if it was "Off", or
deactivate if it was "On".
WaRNING
Before locking, ensure that the oven door is
properly closed. If not, it will not lock and an
alarm will sound.
Teka Hydroclean
This function makes it easy to remove grease
and other food debris that may have stuck to
the sides of the oven.
For easier cleaning, do not allow dirt to accu-
mulate. Clean the oven frequently.
pRoGRaMMING THE TEKa
HYDRoClEaN FUNCTIoN
®
WaRNING
Do not pour water into a hot oven as this can
damage the enamel of the oven.
symbol on the
function
®
If this happens, switch off the alarm by
pressing any clock button, close the door
properly and lock again as per the instruc-
tions above.
3. Once the door has been fully locked/un-
locked, the display will show the new door
status.
In the event that the locking system is ac-
tive, the symbol will appear constantly lit
on the display.
IMpoRTaNT
To unlock the door during cooking, turn the
function dial to standby and unlock the door
as described above.
Once the door is unlocked, turn the function
dial back to its former position to continue
cooking.
Always run the cycle on a cold oven. The result
could be affected and the varnish damaged if it
is run when the oven is too hot.
First remove the trays and all accessories from
the oven interior, including the tray supports
and telescopic guide rails.
To do this, follow the instructions in the in-
stallation and maintenance guide accom-
panying the oven.
1. With the oven cold, spread a cloth out on the
bottom of the oven
English
29
User's Guide