Whirlpool GLADIATOR FREEZERAT Manual De Uso Y Cuidad página 10

Adjusting Controls
The settings indicated in the previous section should be correct for
normal household usage. The controls are set correctly when milk or
juice is as cold as you like and when ice cream is firm.
If the temperature is too warm or too cold in the lower or upper
compartment, first check the air vents to be sure they are not
blocked.
If you need to adjust temperatures, use the settings listed in the chart
below as a guide. Wait at least 24 hours between adjustments and
then recheck the temperatures.
CONDITION/REASON: ADJUSTMENT:
LOWER COMPARTMENT section Adjust LOWER
too warm COMPARTMENT Control
- Door opened often, large amount toward coldest.
of food added or room temperature
very warm
UPPER COMPARTMENT section
too warm
- Door opened often, or large
amount of food added or very cold
room temperature (can't cycle often
enough)
If in Refrigerator Mode,
adjust UPPER
COMPARTMENT Control
toward coldest.
If in Freeze mode, adjust
LOWER COMPARTMENT
Control toward coldest.
LOWER COMPARTMENT section
too cold
- Controls not set correctly for your
conditions
Adjust LOWER
COMPARTMENT Control
toward cold.
UPPER COMPARTMENT section too
cold
- Controls not set correctly for your
conditions
If in Refrigerator Mode
adjust UPPER
COMPARTMENT Control
toward cold.
If in Freeze mode, adjust
LOWER COMPARTMENT
Control toward cold.
UPPER COMPARTMENT
FEATURES
To Remove and Replace the Shelf:
1. Remove the shelf by lifting the entire shelf slightly and moving it
all the way to the left-hand side. Tilt the right-hand side up and
out of the shelf supports.
2. Replace the shelf by inserting the left-hand end all the way into
the shelf supports. Then, lower the right-hand end of the shelf
and insert it into the shelf supports.
NOTE: The shelf should lower slightly and lock into place. If the shelf
does not appear stable, make sure both ends of the shelf are
inserted into the shelf supports.
LOWERCOMPARTMENT
FEATURES
For storage flexibility, the shelves in your convertible refrigerator/
freezer are adjustable. Adjust the shelves to different heights and
store similar foods together. This reduces the time the door is open
and saves energy.
Half-width Shelf/Frame
To Remove and Replace a Shelf/Frame:
1. Remove the shelf/frame by tilting it up at the front and lifting it
out of the shelf supports.
2. Replace the shelf/frame by guiding the rear shelf hooks into the
shelf supports. Tilt the front of the shelf up until rear shelf hooks
drop into the shelf supports. Check to make sure that the shelf is
securely in position.
Full-width Shelf
To Remove and Replace the Shelf:
1. Remove all items from the shelf. Remove the shelf by raising the
front and pulling it forward.
2. Replace the shelf by lifting the front while sliding the shelf back
until it locks into )lace.
L__
\
Half-width Wire Basket
To Remove and Replace the Basket:
1. Remove all items from basket. Remove the basket by lifting the
front out of the slides, then lifting the basket out.
2. Replace the wire basket by lowering the basket into the slides
then pushing the basket backward until it is under the shelf.
To Remove and
Replace the Upper Compartment
Floor:
1. Remove all items from the compartment floor.
2. Remove the floor by raising the front and lifting it out.
3. Replace the floor by inserting the two rear tabs into the holes in
the rear of the lower compartment. Lower the floor onto the liner
of the lower compartment.
10