cecotec IRONHERO 1800 ULTIMATE Manual De Instrucciones página 38

ENGLISH
4. CLEANING AND MAINTENANCE
NOTE
Make sure the iron is unplugged from the mains before cleaning.
-
Disconnect the appliance from the power supply and allow it to cool down completely
-
before cleaning.
Remove the brush head and clean the steam outlet with a damp cloth.
-
Do not use harsh or abrasive cleaning agents or solvents.
-
Do not put the garment steamer in water or any other liquid.
-
Always empty the water tank after each use and rinse with clean water.
-
Clean the housing with a damp cloth.
-
Always ensure the steam outlet hole is clean, free from scaling and not blocked.
-
Once the garment steamer is disconnected from the power outlet, cooled down, water
-
is emptied and the device is clean, it is recommended to wrap the cord safely around the
steamer to store in an upright position.
Cleaning water mineral deposits
To prevent minerals from building up or reduce them, follow the below recommendations:
-
If you do not use water with low dry residue, it is advisable to carry out this procedure
-
once a month.
1. Make sure the appliance is unplugged and cooled down.
2. Mix 50% of descaling product and 50% low-mineral water.
3. Remove the water tank as indicated before, open the rubber plug and carefully pour the
solution into the tank. Put the plug back.
4. Allow it to take effect for 40 minutes and then empty the tank.
5. Fill the tank with clean water, rinse, and empty. Repeat this step until any odour
disappears.
- This process only cleans the water tank.
Do not plug the device during this process.
-
5. TROUBLESHOOTING
Problem
The iron does not
produce steam
38
IRONHERO 1800 ULTIMATE
Solution
* Make sure there is enough water in the tank.
* Check whether the corresponding indicator light is illuminated
green.
* Hold the appliance vertically during use.