JMA NOMAD GO Manual De Usuario página 21

PRESENTATION AND INTRODUCTION
1. INTRODUCTION AND GENERAL OVERVIEW
This manual has been written by the manufacturer and
forms an integral part of the basic equipment supplied with
the machine.
This manual provides information that the operator should
be aware of and that will enable safe use of the machine.
SYMBOLS USED IN THIS MANUAL
1. Indicates a dangerous operation for
people and/or proper operation of the
machine.
2. You MUST read this user manual
3. The safety measures indicated in this
manual MUST be followed, especially
when operating or maintaining the
machine.
4. This manual MUST be read carefully
BEFORE using the machine.
Keep this manual in a safe place for
as long as you have the machine and
ensure that it is always available to the
operator.
1.1 OVERVIEW
The NOMAD GO key cutting machine has been designed to
meet European Regulations (EC).
Solutions have been applied to the design that seek to
eliminate risks for the operator when using the machine:
transport, adjustment, use and maintenance. The following
instructions should be followed to ensure proper key
duplication:
- Follow the procedures defined in this manual.
- Always use Original JMA Parts.
- Use JMA key blanks.
- Send the machine to an authorised JMA Customer Service
Centre for regular servicing (a list can be found at the end of
this manual).
IMPROPER USE
The machine must be installed and operated according to
the instructions contained in this manual.
The manufacturer accepts no liability for any material
damage or personal injury if the machine is used improperly
and any improper use will void all guarantees to which the
machine may be subject.
1.2 TRANSPORT AND PACKAGING
The machine comes inside a cardboard box with the
following dimensions:
Width = 320 mm; Height = 380 mm; Depth = 370 mm
Machine weight (packaging included) = 8.5 kg.
When unpacking the machine, check carefully for any
damage that may have occurred during transport.
If you find something out of the ordinary, immediately
notify the carrier and do nothing with the machine until the
carrier's agent has performed the corresponding inspection.
1. To move the machine from one place
to another, only lift the machine by the
base and not by any other parts.
2. The machine must always be
transported in its original packaging to
ensure its physical integrity.
1.3 IDENTIFICATION LABEL
The NOMAD GO key cutting machine comes with an
identification label that indicates the serial or machine
registration number, the name and address of the
manufacturer, the CE mark and the year of manufacture.
This manual has been written by the manufacturer and
forms an integral part of the basic equipment supplied with
the machine.
21 21 21 21 21
EN