Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
To reheat the iron:
1. Lift the iron or move it slightly.
2. The indicator light will stop flashing.
3. The automatic switch-off indicator will light up and the iron will be ready for use.
WARNING:
Never use steam-iron cleaners on the iron, as they may damage it.
4. CLEANING AND MAINTENANCE
Exterior iron surface
-
After unplugging and allowing the iron to cool down, simply wipe it with a damp cloth and,
if necessary, use a mild detergent.
-
Never use aggressive detergents.
Soleplate
-
Starch and other types of residue can be easily removed from the soleplate with a damp
cloth.
-
To avoid scratching the finish, never use a metal scouring pad to clean the soleplate or
place the iron on a rough surface. If synthetic fabrics are ironed at too high a temperature,
not only can the fabric be damaged, but it's possible for the iron soleplate to be covered
with the synthetic fabric's melted residue. The best way to remove synthetic residues from
the soleplate is to heat up the iron and iron an old cotton cloth.
Anti-scale function
-
The anti-scale function is a permanent system inside the water tank used to remove
impurities from the water and reduce problems caused by limescale build-up.
-
To extend the efficiency of the system, occasionally follow these steps:
1. After using the iron, unplug it and allow it to cool down.
2. Fill the water tank up to 3/4.
3. Leave the solution in the water tank for 15 minutes, shake the iron from time to time, and
then empty it.
4. Fill the water tank a second time with water, shake occasionally, and empty it again after
15 minutes.
5. Fill the tank with water for rinsing and empty it.
Auto-clean function
IMPORTANT:
Your iron will give the best ironing results and last longer by auto-cleaning once a month or
32
IRONHERO 3100 CORDLESS
Publicidad
