PeakTech P 3360 Manual De Instrucciones página 60

4. Touch the test probe tips to the circuit or wire you wish to
check.
5. If the resistance is less than 150 ohms (P 3355) or 35 ohms
(P 3360), the audible signal will sound. The display will also
show the actual resistance.
5.12. Diode test
Warning:
To avoid electric shock, do not test any diode that has voltage on it.
1. Set the function switch to "
2. Press the "MODE" button until the "
the display.
3. Insert the black test lead banana plug into the negative COM
jack and the red test lead banana plug into the positive  jack.
4. Touch the test probe tips to the diode or semiconductor junction
you wish to test. Note the meter reading.
5. Reverse the probe polarity by switching probe position. Note
this reading.
6. The diode or junction can be evaluated as follows:
A: If one reading shows a value and the other reading show
OL, the diode is good.
B: If both readings are OL, the device is open.
C: If both readings are very small or 0, the device is shorted.
Note: The value indicated in the display during the diode check is
the forward voltage.
" position.
60
" symbol appears in