PeakTech P 3360 Manual De Instrucciones página 61

5.13. Frequency / Duty cycle measurement
1. Set the function switch to the "Hz" position.
2. Insert the black test lead banana jack into the negative COM
jack and the red test lead banana plug into the positive Hz jack.
3. Touch the test probe tips to the circuit under test.
4. Read the frequency in the display. The digital reading will
indicate the proper decimal point, symbols (Hz, kHz, MHz) and
value.
5. Press the "MODE" button to display duty cycle in %.
5.14. Capacitance measurements
Warning:
To avoid electric shock, disconnect power to the unit under test and
discharge all
measurements. Remove the batteries and unplug the line cords.
1. Set the function switch to the "CAP" ┤├ position.
2. Insert the black test lead banana jack into the negative COM
jack and the red test lead banana plug into the positive ┤├
jack.
3. Touch the test leads to the capacitor to be tested. The display
will indicate the proper decimal point, value and symbol.
capacitors before taking
61
any capacitance