installing your dryer
unpACkInG youR DRyER
Unpack your dryer and Inspect it for shipping damage. Make sure you have received all of the items
shown below. If your dryer was damaged during shipping, or you do not have all of the items, contact
1-800-SAMSUNG (726-7864).
To prevent personal injury or strain, wear protective gloves whenever lifting or carrying the dryer.
Packing materials can be dangerous to children. Keep all packing material (plastic bags, polystyrene,
WARNING
etc.) well out of childrens' reach
Do not move the product while holding the front part of the top cover of the dryer.
CAUTION
-
This may cause the cover to be separated and result in injury.
Tools needed
pliers
level
parts supplied
Rubber washer
bASIC REquIRmEnTS
Make sure you have everything necessary for proper installation
• A GROUNDED ELECTRICAL OUTLET is required. See Electrical Requirements.
• A POWER CORD for electric dryers (except in Canada).
• GAS LINES (if installing a gas dryer). The gas lines must meet national and local codes.
• EXHAUST SYSTEM - must be rigid metal or flexible stiff-walled metal exhaust ducting.
F900A DRY_DV50F_USER MANUAL_DC68-03170D_EN(邀请翻译成 法语+西班牙语).indd 9
Control panel
Top Cover
door
Filter
Frame Front
Cutting knife
pipe wrench (gas only)
phillips screwdriver
"y"- Connector
[ bACK ]
duct exhaust
Nut drivers
duct tape
hose water
short inlet hose
installing your dryer _9
Wrench
2013-1-25 9:26:47