Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION
5.5.3 CHIMNEY
The stack is the final part of the chimney/flue that emerges from the
roof; its function is to disperse smoke and other combustion by-prod-
ucts in the air.
It is important to bear in mind that:
- it must have a suitably sized useful outlet cross-section and none-
theless not inferior to the double the area of the chimney/flue
cross-section
- it must be built in such a way so as to prevent foreign bodies (rain,
snow, birds and other) from penetrating inside it
- it must be built in such a way so as to ensure the dispersion of com-
bustion by-products even in the event of winds from every direction
and inclination
- it must be positioned outside the reflux zone, so as to prevent the
formation of counter-pressures, which could hamper the free dis-
charge into the atmosphere of combustion by-products
- it must be positioned by taking into account the roof pitch and must
respect the proper distances from buildings, plants, antennae and
other obstacles, as specified in the regulations.
> 5 m
>1,85 m
<1,85 m
1
Technical compartment
2
Reflux zone
6
INSTALLATION
a
The appliance MUST be installed by specialised per-
sonnel possessing adequate knowledge of the prod-
uct itself, who must operate in accordance with the
local, national and European regulations; moreover,
said personnel shall be responsible for the correct
installation and efficient operation of the appliance.
The installation MUST be made using adequate
■
equipment and in accordance with the regulations
on health and safety protection.
Adequate personal protective equipment MUST be
■
worn (gloves, safety footwear, etc.).
CS.ST90.IST-1_EN_Rev. 0.0_07-23
< 5 m
1
2
Fig. 7
l
During appliance handling, lifting and unpacking
operations, it is strictly necessary to keep the pack-
aged product in the proper direction as shown by the
pictograms and the indications on the packaging,
so as to avoid damaging delicate parts, such as the
glass-ceramic panel of the door.
6.1
RECEIVING THE PRODUCT
The product is supplied as a single item on a wooden pallet, covered
with nylon wrapping and protected by polystyrene elements and a
cardboard box.
The product is delivered with the following equipment:
- Instructions for installation, use and maintenance
- Stoker
- Warranty certificate
l
The manual is an integral part of the product. It
therefore should be read before installing and com-
missioning the appliance and stored carefully for fu-
ture reference or when the product is transferred to
a new owner.
a
Upon receiving the product, check that the goods
received match the order by comparing the data on
the shipment document with that of the label on the
packaging. In case of discrepancies, immediately
contact the dealer.
Moreover, check that the packaging is intact and
■
lacks any defects or breakages, dents and damaged
parts; if any damages are found, DO NOT USE the
product and contact the dealer immediately.
EN
Fig. 8
13
Publicidad
