Use; Loading The Fuel; Adjusting The Combustion Air; Ignition - klover STAR 90 Instrucciones Para La Instalación, El Uso Y El Mantenimiento

COMMISSIONING AND USE
9

USE

9.1

LOADING THE FUEL

d
It is forbidden to use any fuel other than wood.
It is forbidden to use any highly flammable liquid or
■
gaseous substance such as alcohol, petrol or similar.
l
Before proceeding with the operations described be-
low, consult the chapter "Fuel".
a
Before loading the fuel:
the firebox must be free of ash and residues from
■
the previous combustion; if not, consult
the brazier"
check that the brazier is positioned correctly in its
■
seat inside the combustion chamber: the flat part
must face upwards so that the ash can fall into the
tray without any difficulty.
To load the wood:
- open the firebox door
- arrange small slats of tender wood in the centre of the firebox, plac-
ing them on top of one another and leaving some space in between
- in between the slats add some easily combustible fuel, e.g. paper or
other ignition material available in retail shops.
9.2

ADJUSTING THE COMBUSTION AIR

The combustion air is indispensable for determining flame develop-
ment, the duration and quality of combustion and, consequently, the
thermal yield of the appliance.
Since combustion varies in relation to several factors, for example
the quality and quantity of fuel used, the characteristics of the sys-
tem and the atmospheric and weather conditions, it is necessary to
choose the most suitable adjustment of the combustion air.
d
Never load the firebox excessively with an insuf-
ficient supply of combustion air. This may cause
a consistent formation of unburned gases/fumes
which, in the absence of the flame, may jeopardise
safety.
a
A significant presence of unburned gases or fumes
inside the firebox may spark a sudden flame and, in
some cases, may even cause the glass of the door
to break.
An excessive supply of combustion air may cause
■
quicker combustion resulting in greater wood con-
sumption and a lower yield of the appliance.
CS.ST90.IST-1_EN_Rev. 0.0_07-23
The combustion air can be adjusted by shifting the combustion air
primary damper as follows:
- to reduce the amount of incoming air, shift the device towards the
right
- to increase the amount of combustion air, shift the device towards
the left
"Cleaning of
9.3

IGNITION

l
Verify that the firebox is not empty. If it is, fill it and
perform the operations described in the paragraph
Loading the
d
It is forbidden to use any fuel other than wood.
It is forbidden to use any highly flammable liquid or
■
gaseous substance such as alcohol, petrol or similar.
Proceed as follows:
- open the firebox door
- open the fume damper, the internal fume deflector and the combus-
tion air primary damper
1
2
3
+
fuel.
3
EN
–
Fig. 15
1
2
Fig. 16
17