Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Commissioning and use
7
INITIAL SETTINGS
7.1
REGISTERING THE PRODUCT
Once the product has been installed, the user must register it.
The registration entitles the user to a 2-year warranty as well as pro-
motions and specific services (for example: discounts on spare parts,
facilitated conditions for testing or maintenance, etc.).
Simply access the Web page shown below or scan the following QR
Code using your smartphone.
https://garanzia.klover.it/it/registrazione_prodotto
8
COMMISSIONING
8.1
PRELIMINARY CHECKS
l
Before commissioning the appliance:
carefully read all the documentation accompanying
■
the product and any supplementary accessories
make sure that all the indications provided by the
■
manufacturer and specified in the regulations are
observed
make sure you have completed all the necessary
■
cleaning and maintenance operations of the product
and the system.
a
The commissioning must be MUST BE made by qual-
ified personnel, who must:
perform a switch-on and operation check to verify
■
that the product and all associated and involved ele-
ments of the system work properly.
8.2
INITIAL START-UP
l
Before proceeding with the operations described be-
low, consult the chapter "Ignition".
16
a
Before starting-up the product:
remove any accessories supplied or combustible el-
■
ements from the hotplate or from the ash tray and
free the firebox from the locking elements used dur-
ing transport, if present
check that the brazier is positioned correctly in its
■
seat inside the combustion chamber: the flat part
must face upwards so that the ash can fall into the
tray without any difficulty
when igniting the appliance for the first time, use lit-
■
tle wood chopped into small pieces and observe the
instructions given under
NO
l
During the first ignition attempts, bad odours may
be released due to the evaporation of the greases
or oily liquids used to manufacture the product and
contained in the paint:
adequately ventilated the room where the appliance
■
is installed
avoid staying in the room for too long, as the vapours
■
emitted could be hazardous to people and animals
moreover, during the first few days of use, the appli-
■
ance should be operated at minimum power.
The first ignition is necessary to verify that the appliance works prop-
erly but also to allow the product's body to settle and the greases or
oily liquids used to manufacture it and present in the paint to evapo-
rate fully. During the initial period it is advisable to use the product at
minimum capacity, loading the firebox for the first day with 50% fuel.
At the end of this procedure, greases or oily liquids will have evaporat-
ed, the paint will have stabilised and the product can be used normally.
If necessary, the appliance can be used at maximum capacity until the
substances that cause bad odours have disappeared entirely.
COMMISSIONING AND USE
"Loading the
fuel".
Fig. 14
CS.ST90.IST-1_EN_Rev. 0.0_07-23
Publicidad
