Publicidad
4. Programming the Back Buttons
A. To program, hold the "function" button and press the back button you'd like to map a control to.
B. Once the "function" button LED is flashing, press any button on the controller to map that button's function to the back. The LED will blink
quickly 3 times, indicating successful programming.
C. To clear a mapped function or disable the back buttons completely, hold down the "function" button and double press any back button.
5. Changing the Lighting Effects
A. The Afterglow Wave Wireless Controller comes with four lighting effects pre-programmed on the controller:
•
Wave: Displays a rainbow of RGB lights in a continuous motion.
Breathing: The RGB lights slowly fade in and out on a set color.
•
•
Static: The RGB lights will remain solid and set to a chosen color.
Stick: The RGB will react to the movement of the analog sticks.
•
B. To cycle through these lighting effects, hold down the "function" button and press either the L or R button. Once you choose your mode,
release the "function" button to save the setting.
6. Adjusting the Colors of the Lights
A. Hold down the "function" button and use the Left/Right button on the D-pad to change the LED's color.
B. Once you find the color you'd like, save the setting by releasing the "function" button.
C. For white, hold down the "function" button and click in the left analog stick.
Note: The default LED color for the STICK, STATIC and BREATHING modes is blue. The LED colors for the WAVE and STICK modes cannot be
customized.
7. Adjusting the Brightness of the Lights
Publicidad
