Publicidad
Idiomas disponibles
Idiomas disponibles
Maintenance
Vent sensor
The dryer features a vent sensor that detects and notifies you when it is time to clean the ductwork. Check
the following if you get the "Check the lint filter or vent condition" message when you turn on the dryer.
NOTE
• For duct installation, see Exhaust ducting guide on page 39 and Ducting requirements on page 28.
• The dryer may keep running even if the duct is clogged, but the drying time will be extended.
• When you get the message check the lint filter and the ducts, and clean them if necessary.
• If the message keep appears, it is because the duct is installed or connected with some restrictions (it's
too long or has too many bends). This is not a system failure. However, drying time may be extended or
the drying performance may be degraded.
Mesh filter
Clean the mesh filter of the water hose once or twice a year.
NOTE
If the mesh filter is clogged, an information code of "Check water supply faucets and restart" appears on
the screen.
82
English
Untitled-2 82
1. Turn off the Laundry Hub, and unplug the power cord.
2. Close the water tap.
3. Loosen and disconnect the water hose from the back
of the Laundry Hub. Cover the hose with a cloth to
prevent water from gushing out.
4. Use pliers to pull out the mesh filter from the inlet
valve.
5. Submerge the mesh filter deeply in water so that the
threaded connector is also submerged.
6. Dry the mesh filter completely in the shade.
7. Reinsert the mesh filter into the inlet valve, and
reconnect the water hose to the inlet valve.
8. Open the water tap.
2023-11-09
4:27:04
Publicidad
