Tenda NOVA EX12 Guía De Instalación Rápida página 4

II Connect the node to the internet
*Smartphone used for example
1. Connect the smartphone to the WiFi network of the primary node, and you will be
automatically redirected to the web UI of the device. The SSID and password can
be found on the bottom label of the device.
www.tendacn.com
Made in China
SSID:
NOVA_XXXX_XX
Password:
NOVA_XXXX_XX
Password:
(MX12 used for example)
2. Follow the onscreen instructions to connect the device to the internet. After
the device is connected to the internet, its LED indicator lights solid green.
Tips
If the web UI is not displayed, open a browser on your smartphone and visit
tendawifi.com in the address bar. If you still cannot log in to the web UI,
see Q1 in FAQ.
If you use the device as a single router, now you have completed the settings
and can access the internet with:
- Wireless devices: Connect to your WiFi network using the SSID and password
you set.
- Wired devices: Connect to the LAN ports of your node.
Tips
If you cannot access the internet, see Q2 in FAQ.
Settings
NOVA_XXXX_XX
III Extend network
Step 1: Networking
For 2-pack and 3-pack:
Place the other devices in the kit within 3 meters from the primary node and
power them on. Wait for about 3 minutes. When the LED indicators of these
devices light solid green, the networking is successful and these devices
become secondary nodes in the network.
For 1-pack:
Tips
- Check that the primary node has been connected to internet with the
MESH button function enabled and the new node has been restored to
factory settings.
- If the networking failed, contact Tenda's technical support.
1. Place the node in an elevated and open position within 3 meters from your
existing node.
2. Use the power adapter to connect the node to a power source. Wait about 40
seconds. The node completes startup when its LED indicator blinks green slowly.
3. Press the MESH button of the node for about 1 to 3 seconds. The LED indicator
blinks green fast. Within 2 minutes, press the MESH button of the node of the
existing network for 1 to 3 seconds to negotiate with this node.
When the LED indicator of the node lights solid green, the networking is successful
and the node becomes a secondary node in the network.
Step 2: Relocate the node
1. Refer to the following relocation tips to locate the secondary nodes to a proper
position:
• Ensure that the distance between any two nodes is less than 10 meters.
• Keep your nodes away from electronics with strong interference, such as
microwave ovens, induction cookers, and refrigerators.
• Place the nodes in a high position with few obstacles.
2. Power on the secondary nodes again till these LED indicators blink green
slowly.
02