Rubbermaid 1W21 Manual De Instrucciones página 21

c.
Make sure Front Roof (J) is positioned tightly against the middle Repeat Roof (M) section.
Install Roof Pins (FF) in four places. If necessary, use Roof Pin Assembly Tool (GG) to pull the roof down.
1. Insert pin in slot.
FF
d.
Install Left Door (L) and Right Door (K) into hinge openings
of Front Floor (A) and hinge sockets in Front Roof (J).
Note: Only raise front edge of roof enough to install the
door hinge pins.
J
L
L
A
2. Push all the way through.
GG
Install Roof Pins four places.
J
K
K
A
e.
From inside the shed, install four Screws (AA) into the roof at
each side wall location.
Note: The screws also have to go through the Roof Brace
(RB) at each end to properly secure the roof!
A second person on the outside of the shed should hold
down the edge of the roof firmly at each screw location.
J
3. Rotate head flush with roof.
click
AA (4)
RB
21