Publicidad
Idiomas disponibles
Idiomas disponibles
TOOLS
1
Seal Ring Puller for inner input shaft, to be used as OEM 307-673
2
Seal Ring Guide for inner input shaft, to be used as OEM 307-674
3
Seal Ring Press Tool for inner input shaft, to be used as OEM 307-674
4
Seal Ring Guide for outer input shaft, to be used as OEM 307-672
5
Seal Ring Press Tool for outer input shaft, to be used as OEM 307-672
6
Seal Ring Press Tool for drive shaft, to be used as OEM307-671
ATTENTION
Read the operating instructions and all safety instructions contained therein carefully before using the
product. Use the product correctly, with care and only according to the intended purpose. Non-compliance
of the safety instructions may lead to damage, personal injury and to termination of the warranty. Keep
these instructions in a safe and dry location for future reference. Enclose the operating instructions when
handing over the product to third parties.
INTENDED USE
This tool set is designed for removing and installing the input and output shaft seal rings on 6 speed dry
plate dual clutch gearboxes DPS6/6DCT250 from Ford as found in e.g. Ford Focus (2012-2019), Fiesta
(2008-2019), B-Max (2012-2019) and EcoSport (2013-2019).
SAFETY INFORMATIONS
•
Keep children and other persons out of the working area.
•
Do not allow children to play with this tool or its packaging.
•
Do not use the tool if parts are missing or damaged.
•
Use the tool for the intended purpose only.
•
Never place the tool on the vehicle battery. There is a risk of a short circuit.
•
Be careful when working on running engines. Loose clothing, tools and other objects can be caught
by rotating parts and cause serious injury.
•
Be careful when working on hot engines because of the risk of burn injuries!
•
If you remove the ignition key before repairing, you can prevent the engine from being started
accidentally and resulting in engine damage and personal injuries.
•
This manual serves as a brief guide and does not replace a workshop manual. Always refer to the
vehicle-specific service literature, particularly the technical data such as torque values and
instructions for disassembly/assembly, etc.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Dual Clutch Radial Seal Ring
Tool Set | for Ford
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
BGS 74267
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
Publicidad
