Publicidad
Idiomas disponibles
Idiomas disponibles
Front
1
2
3
4
POWER CORD HOLDER INSTALLATION
Power cord holder will be shipped inside of the water
tank. During initial setup, clip the power cord holder
onto the back side of the unit. (See Figure 1)
Figure 1
Clip power cord
holder onto unit.
POSITIONING THE UNIT
NOTE: This dehumidifier should not be used for
commercial or industrial applications.
• Place the dehumidifier on a smooth, level floor
strong enough to support the unit with a full bucket
of water.
PAGE 7 OF 46
PARTS
Back
5
6
7
8
9
10
11
OPERATION
• Place the unit in an area where the surrounding
temperature will not fall below 41°F. Lower
temperatures will cause permanent damage to the
unit and ice buildup on the coils.
#
DESCRIPTION
1
Control Panel
2
Handle
3
Water Level Indicator
4
Water Bucket
5
Side Air Outlet
6
Air Filter
7
Continuous Drain Hose Outlet
8
Power Cord Holder
9
Pump Drain Hose Outlet
10
Caster
11
Power Cord
40' Pump Drain Hose (Not Shown)
NOTE: For good air circulation and best
performance, allow at least 8" of air space on
all sides of the unit and a minimum of 16" of
air space at the side air outlet. (See Figure 2)
Figure 2
More than 16"
NOTE: Lockable casters are on bottom of the
unit. Do not force the casters to move over
carpet or when there is water in the bucket as
this may lead to tripping and spillage.
QTY.
1
2
1
1
1
1
1
1
1
4
1
1
More than 16"
0124 IH-11032
Publicidad
