Klarstein STUDIO 10 ARC Manual Del Usuario página 26

EN
26
FUNCTIONS AND SETTINGS
Control panel functions
On/Off button (A)
Press this button to turn on the electric fireplace. Two short, high-pitched tones sound
when the power is turned on, and three lower-pitched tones sound when the power is
turned off. After switching on, the following display appears on the screen:
• When switched on, the heating level, the set temperature and
the clock symbol are displayed. The display disappears after
60 seconds without operation. Press any key to switch the
display back on.
• The preset temperature is 10 °C. The heating symbol is
displayed and the heating process starts when the room
temperature is below the default setting (10 °C). In the
opposite case, it is not displayed and does not heat.
• The clock symbol flashes because the time has not yet been
set. Follow the steps described in the chapter „Operating
modes" under „Timer mode" to set the timer.
Temperature key (F) and arrow keys (B/C)
Press the temperature key (F) to start the temperature setting. Press the arrow keys (B/C)
to set the temperature.
• After setting, press either arrow keys (B) or (C) to display the current set temperature
on the screen.
• If the set temperature is higher than the room temperature detected by the unit, the
heating will start. If the set temperature is lower than the detected room temperature,
the heating will not start.