Klarstein STUDIO 10 ARC Manual Del Usuario página 36

EN
36
Note: To save the settings made, always press the OK button. A maximum of 8
heating periods can be programmed for one program.
After the manual setting for the weekly timer is completed, the selected program will
overwrite the default preset values.
RESTORE DEVICE TO FACTORY DEFAULT
SETTINGS
If the mains plug is plugged in and there is a 0/I switch, set it to "I". The appliance is in
standby mode. (Do not press the On/Off button). Then press and hold the arrow key (C)
for 3-6 seconds until you hear a beep. Then unplug the appliance and switch it on
again after 10 seconds to restore the factory settings.
CLEANING AND CARE
Note: Do not open the device. Repairs may only be carried out by qualified
personnel. Always switch off the appliance before cleaning and caring for the device.
Glass cleaning
Over time, the glass pane can become dirty or dusty. Dust can be removed by gently
rubbing the glass surface with a clean, lint-free cloth or paper towel. To remove
fingerprints or other marks, use a soft, damp, lint-free cloth with a high-quality
household glass cleaner. The glass should always be completely dried after cleaning
with a lint-free cloth or paper towel.
Note: Do not use abrasives on the glass. Do not spray liquids directly on the surface
of the appliance!
Storage
Disconnect the device from the power socket when not in use and store it in a dry, dust-
free location.