Hilti EXO-T-22 Manual De Instrucciones Original página 25

▶ If the battery is too hot to touch, it may be defective. Put the battery in a place where it is clearly visible
and where there is no risk of fire, at an adequate distance from flammable materials. Allow the battery to
cool down. If it is still too hot to touch after an hour, the battery is faulty. Consult Hilti Service or read the
document entitled "Instructions on safety and use for Hilti Li-ion batteries".
Observe the special guidelines applicable to the transport, storage and use of lithium-ion batteries.
→ page 26
Read the instructions on safety and use of Hilti Li-ion batteries that you can access by scanning
the QR code at the end of these operating instructions.
3 Description
3.1 Product overview
3.2 Intended use
The product described is a cordless, active human-augmentation device for bearing weight. It is designed
for bearing the weight of an attached Hilti SDS-max combihammer, breaker or demolition hammer.
• For this product, use only Hilti Nuron lithium-ion batteries of the B 22 series. For optimum performance,
Hilti recommends the batteries stated in the table at the end of these operating instructions for this
product.
• For these batteries, use only Hilti chargers of the type series stated in the table at the end of these
operating instructions.
3.3 Items supplied
Wearable weight-bearing device, holder for power tool, operating instructions
Other system products approved for use with this product can be found at your local Hilti Store or at:
www.hilti.group
*2375781*
1
2375781
Engaged position for boom
@
Release button for boom
;
Boom
=
Buffer
%
Load-bearing cable
&
Hook
(
Cable for remote control unit
)
Shoulder strap
+
Chest strap
§
Remote control unit
/
Supporting strut
:
Length adjuster for waist belt
∙
Waist strap
$
Battery
£
Height adjuster
|
Release button, battery
¡
Battery state of health indicator
Q
On/Off button
W
LED operating-status indicator (green)
E
Up button
R
Down button
T
Charge state indicator for battery
Z
English 19