Publicidad
Idiomas disponibles
Idiomas disponibles
Aligning
the Steering
Levers
(Figure 14)
1. Shut OFF engine. Engage parking
brake. Remove the ignition key.
2. Place seat in the service position (See
Service Position on page 18).
3. Loosen brake interlock on the same side
as steering lever to be adjusted.
4. Loosen tie rod jam nuts and turn tie rod
until steering levers are aligned.
5. Tighten jam nut on tie rod, tighten brake
interlock.
1. Tie-Rod Jam
4. Brake
Nut
Interlock
2. Tie-Rod
5. Hydrostatic
3. Steering
Transmission
Lever
Figure 14
OF3381
ADJUSTING THE UNIT TO TRACK
STRAIGHT
WARNING:
Prior to adjusting the
tracking of the unit, shut OFF
engine, engage parking brake,
and remove the ignition key.
Check and adjust tire pressure. Increase
pressure on side unit tracks to. DO NOT
exceed maximum recommended
tire
pressure (See Specifications
on page 31 ).
If tire pressure adjustment does not solve
tracking problem, adjust the limiter bolts on
the stop bracket (Figure 15). Front bolts
adjust forward and rear bolts adjust reverse.
Lengthen the limiter bolt (move closer to
lever) on side which is too fast.
1. Limiter Bolt
2. Jam Nut
3. Steering
Lever
Figure 15
4. Stop
Bracket
GB - 24
Publicidad
