Publicidad
Idiomas disponibles
Idiomas disponibles
CTP 2500
• Do not pull on the connection cord, but rather on the
plug, to separate the appliance from the mains.
• Do not leave the appliance unattended when it is
switched on, as this may be a source of danger.
DESCRIPTION
1. Precision cutting selector.
2. ON/OFF push-button.
3. Battery and indicator light.
4. Blades
5. Guide combs.
6. Oil bottle
7. Brush
8. Power supply adaptor
NOTE:
Guide combs give different length of cut by
different sizes. For getting used with this hair
clipper, we advise you to start with long length.
TECHNICAL SPECIFICATION
Rated Voltage: 230V~ 50Hz
Charging Time: 4 hours
HOW TO USE
1. This hair clipper can be used with or without cord. If you want to use it with cord and the battery is fully
discharged, it cannot work, wait 1 minute to charge it a little. On the other side, it is normal that body is a
bit hot while you are using it with cord or when it is fully charged.
2. Connect the adaptor to charging connection on bottom side of the appliance, after plug the adaptor to
the mains. Indicator light will light in red and the battery will charge. You also can charge the battery out
of hair clipper connecting the adaptor to it, for removing the battery unscrew the base and remove the
battery. For full charging it needs 4 hours, after that it can be used for more than 300 minutes. It is
recommended for first charge of battery or after 6 months with no use, 10 hours of charging to active the
rechargeable battery activity. Avoid long time recharge (for more than 6 hours) or lifespan of battery will
reduce considerably
3. Turn on the appliance with ON/OFF push-button, push it to switch on. Push it again to switch off.
USING OF ACCESSORIES
When you mount or dismount the combs, the appliance should be switch off.
1. Choose the guide comb according desired length (3, 6, 9, 12mm).
2. Place the comb facing its rail guide and rail guide of hair clipper and push it until hear a click. See below
pic.
10
Publicidad
