Publicidad
Idiomas disponibles
Idiomas disponibles
A CAUTION!
♦
If the red control LED 25 flashes, this means that the battery pack 5 has overheated and cannot
be charged.
♦
If the red and green control LEDs 25 26 both flash, this means that the battery pack 5 is broken.
♦
Push the battery pack 5 back into the appliance.
■
Never recharge a battery pack again immediately after rapid charging. There is a risk that the
battery pack will overheat and this will reduce the lifespan of the battery.
♦
Switch off the charger for at least 15 minutes between successive charging sessions.
To do this, disconnect the power plug.
Attaching/disconnecting the battery pack to/from the appliance
Inserting the battery pack:
♦
Allow the battery pack 5 to click into place in the appliance.
Removing the battery pack:
♦
Press the release button④and remove the battery pack.
Checking the battery charge level
♦
Press the battery charge level button 22 to check the status of the battery (see also main diagram).
The status will be shown on the battery display LED 23 as follows:
♦
RED/ORANGE/GREEN = maximum charge RED/ORANGE = medium charge
RED = low charge - charge the battery
Initial operation
Fitting/changing the saw blade
Remove the battery before carrying out any work on the power tool (e.g. maintenance, changing
tools, etc.) as well as during the transport and storage of the power tool.
Unintentional activation of the ON/OFF switch can result in injury.
♦
Press the blade guard together 18 at the height of the outer catches and pull it off to the front.
♦
Turn the quick-release chuck 17 and hold if in this position.
♦
Push the required saw blade into the quick release chuck 17 as far as the stop.
♦
Release the quick-release chuck 17 so that it returns to its initial position. The saw blade is now
locked.
■
CAUTION! The saw blade teeth must face the front (see fold-out page)!
Fitting the blade guard
Fit the blade guard 18 before you connect the appliance to a dust extractor.
♦
Fit the blade guard 18 onto the appliance so that the two outer catches engage in the recesses in
the housing.
♦
Remove the blade guard 18 for working without a dust extractor or when making mike cuts.
To do this, press the blade guard together 18 at the height of the outer catches and pull it off to the
front.
Fitting the rip fence
The rip fence 11 can be fitted on the left or right of the appliance.
♦
Undo both the clamping screws on the insertion openings 15.
♦
Push the rip fence 11 into the insertion openings15
♦
Retighten the two locking screws.
Connecting the sawdust extractor
♦
Push the extraction nozzle 6 into the vacuum extraction duct until it is secured in place. Optional,
depending on the diameter of the dust and sawdust extractor.
♦
Attach an approved dust and sawdust extractor to the extraction nozzle 6
■
Wear a dust mask.
All manuals and user guides at all-guides.com
- 08 -
Publicidad
