Publicidad
Idiomas disponibles
Idiomas disponibles
Use only the following battery to operate the cordless tool:
Type
Rated voltage
Capacity
Cells
Use only the following high-speed battery charger to charge the cordless tool:
INPUT:
Rated voltage:
Rated power consumption:
Fuse (internal):
OUTPUT:
Rated voltage:
Rated current:
Charging lime:
Protection class:
Noise emission value:
Noise measurement value determined in accordance with EN 60745. The A-rated noise level of the
power tool is typically as follows:
Sound pressure level: l
Sound power level: l^
A
Uncertainty K:
K
WA
Wear hearing protection!
Total vibration value:
(vector total of three directions) determined in accordance with EN 60745:
Cutting boards: a
= 5.9 m/s2
hB
Uncertainty K = 1.5 m/s2
Cutting sheet metal: a
hM
Uncertainty K = 1.5 m/s2
NOTE
►
The vibration level specified in these instructions has been measured in accordance with the
standardised measuring procedure specified in EN 60745 and can be used to make equipment
comparisons. The specified vibration emission value can also be used to make an initial exposure
estimate.
WARNING!
►
The vibration level will vary according to the use of the power tool and may sometimes be higher
than the value specified in these instructions. Regular use of the power tool in this way may cause
the user to underestimate the vibration. Try to keep the vibration loads as low as possible.
Measures to reduce the vibration load are, e.g. wearing gloves and limiting the working time.
Wherein all states of operation must be included (e.g. times when the power tool is switched off
and times where the power tool is switched on but running without load).
All manuals and user guides at all-guides.com
120V 60Hz(alternating current)
= 80 dB (A) Uncertainty K:
PA
K
= 3 dB
PA
= 91 dB (A)
= 3 dB
= 7.2 m/s2
LITHIUM ION
20V=(DC)
2.0 Ah
5
65 W
3.15A
21.5 V (DC)
2.4 A
approx. 60 min
(double insulation)
- 04 -
Publicidad
