TACKLIFE DJS20A Manual Del Usuario página 12

Supporting the extraction function:
Press the sawdust blower switch 7 to the "O" position.
♦
Sawdust blowing function
Switching the sawdust blowing function on:
Press the sawdust blower switch 7 to the
♦
Fitting the splinter guard
The splinter guard 14 can prevent the tearing up of the surface when sawing wood. The splinter guard
14 can only be used with certain sawblade types without the sliding shoe 9 and only at a cutting angle
of 0°.
Press the splinter guard 14 into the footplate 8 from below (notch facing upwards).
♦
Fitting the sliding shoe
When working on sensitive surfaces, you can fit the sliding shoe 9 on the baseplate 8 to prevent
scratching the surface.
Mount the sliding shoe 9 onto the front of the baseplate 8 and press it up at the back until it clicks
♦
into place on the baseplate 8.
To remove the sliding shoe 9 ,unfasten it at the rear of the baseplate 8 and slide it off the front.
♦
Use
Setting the cutting angle
♦ Undo the clamping screws 20 with the supplied hex key and pull the baseplate 8 to the rear.
Adjust the cutting angle to 0°/15o/30o/45° with the aid of the markings on the baseplate 8 Push the
♦
baseplate 8 forwards so that the locking pin engages in the toothing 21 .
Retighten the clamping screws 20 with the hex key.
♦
NOTE
When using a cutting angle of 15°/30°/ 45°, the blade guard 18 and the splinter guard 14 must be
►
detached beforehand.
Setting the stroke rate
The ON/OFF switch 2 has a variable speed control. Press the ON/OFF switch 2 lightly for a low
speed. Increasing the pressure increases the speed.
NOTE
The integrated motor brake ensures rapid stoppage.
►
Adjusting the pendulum stroke
♦ You can use the pendulum stroke switch 10 to adjust the pendulum movement of the saw blade
13 You can achieve fine, clean-cut edges without pendulum movement (setting "0"). Deactivate
pendulum movement when working on thin workpieces. You can achieve an increasingly fast work
All manuals and user guides at all-guides.com
position.
- 09 -