Descargar Imprimir esta página

Lifetime 60393 Instrucciones De Ensamblaje página 40

Caseta exterior de 2,4 x 3,0 m

Publicidad

SECTION 7 (CONTINUED) /
TOOLS AND HARDWARE REQUIRED /
7.1
• There is a narrow groove (illustrated in black) running along the outside of the window on the back of each narrow
window wall panel (BDH & BDI). Starting at the top, left corner of the groove in one of the narrow window wall panels,
lay a 1/8 in (3,2 mm) strip of the tan butyl tape (EPH) into the groove. Do not worry about getting the strip completely into the groove just
yet—simply lay the strip over the groove. Do not press the strip into the groove. Work your way downward (1), and curve to go along the
bottom (2) of the window. Curve your way upward (3) and then along the top (4) of the window until you're back
where you started. Clip off the excess.
• Une rainure étroite (illustrée en noir) se trouve le long de l'extérieur de la fenêtre à l'arrière de chaque panneau
mural étroit. Partant du coin supérieur gauche de la rainure dans un panneau mural étroit avec fenêtre, étendez
une goutte de 1/8 po (3,2 mm) de ruban de caoutchouc butyl couleur sable (EPH) dans la rainure. Ne vous inquiétez pas si la goutte n'est
pas complètement dans la rainure en ce moment, ne faites que déposer la goutte sur la rainure. Ne poussez pas la goutte dans la rainure.
Travaillez vers le bas (1), et courbez pour atteindre le bas (2) de la fenêtre. Courbez vers le haut (3), puis le long du
haut (4) de la fenêtre jusqu'à ce que vous reveniez au point de départ. Coupez l'excédent.
• Hay una ranura angosta (ilustrada en negro) bordeando la ventana en la superfi cie posterior de cada panel
mural angosto con ventana. Comenzando desde arriba, en la esquina izquierda de la ranura en un panel, aplique
una línea de 1/8 in (3,2 mm) de cinta butílica de color cuero (EPH) en la ranura. Ne se preocupe por poner la cinta, mas solamente ponga la
cinta sobre la ranura. No presione la cinta dentro de la ranura. Siga hacia abajo (1), y curvéela a lo largo del borde inferior (2) de la
ventana. Curvéela hacia arriba (3) y, entonces, a lo largo del borde superior (4) de la ventana hasta estar al punto
de partida. Corte el exceso.
Groove /
Rainure
/
Ranura
SECTION 7 (SUITE)
/
SECCIÓN 7 (CONTINUACIÓN)
OUTILS ET QUINCAILLERIE REQUIS
4
/
INSTRUMENTAL Y HERRAJE REQUERIDOS
1
EPI (x2)
40
3
2

Publicidad

loading