Oxford
®
Classic Lifts
3. Assembly and Commissioning Instructions
Place the carton in a clear working area and open carefully. The carton contains:
• Main wheeled chassis
• Mast and boom assembly
• Battery pack (electric lifts only)
1.
Remove all the parts from the carton and place on the floor, taking care to protect the
finish from damage.
Some of the parts are heavy and will need to be lifted with care. You may need
assistance with the heavier assemblies.
2.
Apply the rear castor brakes by pushing the brake levers (Fig. 5) downwards.
3.
Fit the mast assembly to the chassis. The mast is located into the rectangular socket on
the top centre of the chassis. (Fig. 5 - manual leg model shown).
Avoid trapping fingers. Keep fingers away from the end of the mast when inserting
into the socket.
Brake Lever
Mast Locking Knob
4.
When the mast is fully engaged within the socket, turn the mast locking knob (Fig. 5)
clockwise, until fully tightened.
Full engagement of the mast is indicated by the label on the side of the mast.
6
• Wallet containing documents
• Battery charger (electric lifts only)
• Hand control (electric lifts only)
WARNING
WARNING
Mast Assembly
WARNING
Rectangular Socket
Brake Lever
Fig. 5
English